Organic silicon thermal insulation potting AB adhesive

Organic silicon thermal insulation potting AB adhesiveMeets international environmental standards and has passed EU ROHS standards and SGS testing; It is a two-component room temperature curing silicone sealant designed for insulation and waterproof sealing of power switches. It is a thermal conductive silicone sealant,.

Scope of application: Suitable for insulation and sealing protection of electronic circuit boards and components used in harsh environments such as humidity, vibration, and corrosiveness.

This product overcomes the disadvantage of slow deep curing of single component silicone sealant Simultaneously cured on the surface, it has good process performance, excellent insulation and sealing performance, resistance to arc, corona, aging, high and low temperature, and is suitable for pouring and pouring large-area deep bonded seals. This product has excellent thermal conductivity.

Product features:

Resistance to corona discharge and aging

Strong thermal conductivity

Compliant with the VOCS national standard emission GB30981-2020

Insulation waterproof sealing

Application industry:

Widely used in industries such as electronics and electrical, new energy vehicles, 5G communication, photovoltaic energy, etc.

• Before using insulation potting AB adhesive, please use a dry cotton cloth or sandpaper to remove dust, oil stains, rust, etc. on the bonding surface, and then wipe it with a diluent or trichloroethylene cleaning agent to clean the bonding surface and enhance the adhesion of the adhesive.
• Unscrew the front cover and it can be used. If there is insulation sealing AB glue on the bottle mouth, first wipe the glue clean with a cotton cloth, and then put on a needle or PE dropper before use to control the glue flow and ensure the bonding effect.
• Drop a small droplet of insulating potting AB glue on the surface to be bonded immediately and hold until it hardens, with curing time varying from a few seconds. The reinforced adhesive can reach practical strength in about 30 minutes, and the highest strength can be obtained after 24 hours.
• Clean the insulation sealing AB glue bottle mouth after use and tighten the lid.
• After use, please store the unused insulation potting AB adhesive in a cool and dry place

Product precautions for safer use

• 1. Do not wear woven gloves for use. The insulation and sealing AB glue of Juli brand will quickly undergo polymerization reaction when absorbed by the weaving material of the gloves, generating high heat and burning your hands. Therefore, please remember not to wear woven gloves for use.

• If the eyes accidentally come into contact with the glue, it may damage the eyes due to the hardness of the glue after curing. Do not rub with your hands, and immediately rinse with plenty of water or apply a warm towel to make the eyelids sweat and naturally separate. Do not forcefully pull them apart. In severe cases, seek medical attention for emergency treatment.

• When in contact with the skin, soak in warm soapy water and remove with Juli brand series adhesive remover.

• 4 Research Platinum brand insulation potting AB glue has an irritating odor, please keep the workplace ventilated when using it in large quantities

• When there is a large amount of leakage, it can be cured with water and then scraped off

• After completing the operation, the unused glue should be immediately tightened with a cap and sealed for storage. When reusing, if there is a slight crust on the sealing area, it can be removed without affecting normal use.